Double row ball bearing with seal and retaining ring kit. Perfect for an open primary system or for added durability in a high-output system. Made in the U.S.A..
Alerts you when metal has reached 210 degrees F, the temp at which you should cease heating mainshaft, flywheel sprocket shaft, motor or transmission case when trying to remove stubborn bearings, r...
Made in the USA. Sold in pairs. Replaces OEM #8998.Vehicle Fitment:1980-1983 Harley Davidson FLH Electra Glide 1980-1981 Harley Davidson FLHC Electra Glide Classic 1980-1981 Harley Davidson FLHS El...
Removes the main drive gear from the main bearing correctly while in the transmission case. Eliminates the need of an arbor press and the risk of case damage. Use on all Twin Cam 6-speed cruise dri...
Accurately install a lubed ball bearing into the transmission trap door. Also removes bearing without error and can be performed on a work bench, no need for an arbor press. Use on all Twin Cam 6-s...
Wheels change and so have we. This new support plate provides accurate and precise bearing removal and installation on the latest Harley- Davidson cast wheels without risk of damage. The plate atta...
Designed to protect the left engine case while servicing the inner balancer bearings or performing other general engine work. These blocks attach to the outer side of the engine case underneath the...
Wont mar or slip. Installs/removes clip professionally with just one hand in seconds. Constructed of tough black Delrin. For use on all V-twins that use pushrod clips. Made in the USA.
An inexpensive way to clean up threads on frames or other parts that have been powder-coated or painted. Includes coarse sizes 1/4-20, 5/16-18, 3/8-16, 7/16-14, 1/2-13 and 9/16-12. Zinc-plated stee...
Slimmest oil filter wrench in the industry. Exclusive design makes it much easier to navigate near both the oil cooler and the crankcase position sensor and allows you more room to work around the ...
Easily aligns the ignition switch housing as the retaining screws are being torqued, giving the ignition switch knob the alignment it needs to help extend the life of the ignition switch housing.Ve...
Easily aligns the ignition switch housing as the retaining screws are being torqued, giving the ignition switch knob the alignment it needs to help extend the life of the ignition switch housing.Ve...
Used to remove and install Timken bearing race from engine case. Note: Use Bikers Choice driver handle..Vehicle Fitment:1977-1979 Harley Davidson XLCH 1977-1985 Harley Davidson XLH1000
For 84-99 Big Twin, except Twin Cam. Use to line-ream pinion bushing in cam cover from right case race. A must for any serious engine builder. Can also be used to ream idler gear bushings on 57-E8...
Most late model motorcycles are now using hollow axles for reduced weight and also a cost savings. Using the hollow axle has eliminated the center point of the axle. This tool will provide the corr...
This tool is used to gain access to the fuel filter or fuel pump assembly and all other parts located inside the gas tank. Removes the fuel tank cam retaining ring safely and without causing damage...
