Use to remove and install the main seal in all 4-speed Big Twins. This tool will push the seal as flat and straight as possible to .050 below the housing for a no leak fit.Vehicle Fitment:1982-1983...
This tool will easily remove bushings or roller bearings from stock or aftermarket rocker arms. Made in USA.Vehicle Fitment:2012-2015 Harley Davidson FLD Switchback 1966-1969 Harley Davidson FLFB E...
Late style puller is bored to accept end of clutch pushrod eliminating removal of transmission end cover on vehicles equipped with late style throw out bearing.Vehicle Fitment:1936-1937 Harley Davi...
Designed to remove both front and rear counter-balancer shaft bearing assemblies from the left engine case on the new 96 and 110 B engines.Vehicle Fitment:2012-2017 Harley Davidson FLS Softail Slim...
Checks alignment of Big Twin transmission shifter forks and transmission gears. A must have tool for proper shifter clutch alignment and gear dog engagement.Vehicle Fitment:1941-1950 Harley Davidso...
Checks alignment of Big Twin transmission shifter forks and transmission gears. A must have tool for proper shifter clutch alignment and gear dog engagement.Vehicle Fitment:1979-1984 Harley Davidso...
can also be used to install splined pinion gear on 51-55 Big Twin models Use to remove pinion gear. Made in the U.S.A.Vehicle Fitment:1984-1985 Harley Davidson FLH Electra Glide 1984 Harley Davids...
Used to remove or install the oxygen sensor on all closed loop fuel injected H-D models. Socket has a 3/8in. drive receiver or can be used with a 7/8in. wrench. Will withstand up to 125 ft/lbs of t...
When torquing down the axle nut after the proper belt tension has been set (deflection), the welded axle nut will move to the low side of adjuster cam. This movement will allow the belt to lose adj...
Use to install inner cam bearing. Must be used with handle. Made in the USA.Vehicle Fitment:1957-1959 Harley Davidson XL 1958 Harley Davidson XLC 1958-1979 Harley Davidson XLCH 1972-1985 Harley Dav...
Used to rotate the flywheel assembly when doing pushrod adjustments, when building big inch engines or when checking operating clearances such as piston to piston or valve to valve. Can also be use...
Great time saver stem nut tool for use on Touring models. Normally, access to the top stem nut would require the removal of the radio package. With this tool youre able to loosen, tighten and torqu...
Installs main drive gear. Can be performed with the transmission still in the frame with hand tools. Holds the main drive gear square to its bearing bore, eliminating any marring of gear or bearing...
Installs main transmission case bearing by using hand tools. Holds bearing square to its bore, eliminating any marring of the bearing bore.Vehicle Fitment:2013-2016 Harley Davidson FLD Switchback 2...
Holds both cams in an upright position while lowering the cam support plate over both guides and cam journal guides. Manufactured from non-marring material that will not damage any of the cams surf...
Manufactured from 1/2in. thick A36 hot-rolled steel. Incorporates design provisions for both touring and Softail models. Simply install the tool on the primary side of the case and easily split the...
Removes the inner cam bearing. Insert puller collet into the cam bearing ID Insert dowel pin, place remover body over collet, lube threads and with hand tools the bearing is pulled from case. Keeps...
